- #East west symphonic choirs word builder note stuck driver#
- #East west symphonic choirs word builder note stuck mac#
Then simply use the recorded samples in your song. I have better results with just hooking up my midi directly to Wordbuilder and then only send the MIDI data to Renoise using the virtual midi cable (Midi Yoke in my case) and record the results. That should work, but i don’t hink it is the best use for Wordbuilder.
Record a few notes in the pattern editor using the MIDI instrument, then select the Choirs play plugin instrument and simply play your pattern. Then from there send a signal back to the IAC outport that you have defined in Renoise as your midi in. Then start up Wordbuilder and pick your choir scheme. I believe you have to start Renoise first, then open your Play library and add another instrument in which you control a MIDI instrument (you have to point that MIDI instrument to your IAC port that is attached to your Wordbuilder MIDI in port). I think the problem lies a bit in the order of starting what program. I’ve been experimenting with this a little bit when i had some spare time but also ran into a few problems.
#East west symphonic choirs word builder note stuck mac#
I have Wordbuilder and symphonic choirs myself, but not on Mac though.
It can’t concurently, but you can program Renoise to make it send notes using a MIDI instrument that broadcasts the notes to the wordbuilder. If wordbuilder is some kind of midi outputting VST, renoise can’t route that midi into an instance of the the east west plugin running concurrently… I’m not sure what wordbuilder is, but renoise’s midi routing capabilities are pretty limited in comparision to most DAWs. Has anyone had any luck being able to send midi notes to WB via Renoise and having WB work in conjunction with EWSC instantiated as a plug-in withing Renoise?Īny and all help is greatly appreciated. I was pretty thorough during my testing and so I’m sure it is not a slight over sight such as midi channels not set properly.
#East west symphonic choirs word builder note stuck driver#
I did have some success using the following: Seding to WB via IAC driver (bus 1) and sending to EWSC via IAC driver (bus 2) only renoise would freeze with this sort of a configuration. The midi info seems to make it fine to word builder only i can not seem to get the output of word builder to reach EWSC instantiated as a VST/AU plug-in within Renoise. I have tried various combination for example sending to WB via wordbuilder and sending out of word builder via IAC driver bus. Renoise sending midi to Word builder via one of the following: WordBuilder, Renoise Midi, OSX IAC driverĪnd returning to EWSC as both AU and VST plugin in renoise set to accept one of the following (in pref/midi/midi in) renoise in, or Word builder, OSX IAC driver. I have tried the following with no success… I am on running Renoise 2.5 on a Mac 8 core/OSX 10.6 Has anyone been able to successfully run Renoise -> Word builder -> East West Symphonic Choirs?